Porterfield Airplane Club

Keep the Skinny Birds Flying Safely

I recently replaced the landing gear rubber on our 1940 LP65. The old ones were cracked and sagging and in dire need of replacement. I talked with Leroy Blum about this via the telephone, and he was very informative. I acquired the rubber stock from L.A. Rubber at a reasonable cost. On this website, I found a link to a photo of the original blueprint showing the proper dimensions (diameter, square hole size, and radius of corners) Near our airport, Arlington Municipal (AWO), I found an aeronautical fab shop with a water jet cnc machine, and they were happy to cut them out for me at a resonable charge. They came out perfect, and much more consistent than I could of managed with a hole saw and drill press.
They are presently installed and work/look great. Leroy suggested to install the new rubber and existing 40 thousands spacers with dry graphite so everything can work together without binding. Just an FYI for anyone interested.

Thanks Mark, NC27249

Views: 117

Comment

You need to be a member of Porterfield Airplane Club to add comments!

Join Porterfield Airplane Club

Comment by Mark on October 14, 2016 at 7:48pm
If you do a search for "Drew White" on this website, and look for his comment on Feb. 26, 2010, there's some dialog about this topic, and a link to a photo of the original drawing for the shock rubber and aluminum spacer disc. It's a little hard to read, but I was able to get the dimensions from that.
Good luck, Mark
Comment by Shawn Mielke on October 14, 2016 at 2:35pm

Is there any way you could help us find the dimensions of the landing gear rubber or let us know where you found them?  Thanks 

© 2017   Created by Tom Porterfield.   Powered by

Report an Issue  |  Terms of Service

Free Web Counter
Free Web Counter